My Most Popular Friday AM Quick Tip of 2013


As 2013 draws to a close, here’s a look at my most popular Friday AM Quick Tip for 2013. This one is right up the do-it-yourself (DIY) alley

********************

Securing dosing lines and any other line that carries liquid into your tank is an easy step to prevent tank emergencies. And with a saw, a drill and a short piece of PVC, you can make your own effluent line holder as seen in this tip:

 

Browse the Store! Questions?

Comments for this article (5)

  • Crewsfish says:

    Headed to the shed for PVC. Great tip. Love the DIY stuff.

  • Robert says:

    Hi Mark, great tip. But I had to run my additive lines to the main tank. When I had the lines going to my sump the additives (Alk, cal, mag) had some kind of reaction with my GFO/Carbon in the reactors and would make both hard as a rock where I had to chip and dig the GFO and Carbon out of the reactors. When I ran the lines to the main tank where the additives were more mixed with system water the problem stopped. Any ideas

  • alejandro says:

    I tried this a few months back and haven’t looked back since. This diy project works well and was easy to make!

  • Lyle says:

    Hey Mark that was a Great tip! Different then how I thought u were going to show it! I might just have too send you a bottle of my exclusive honey that I get from my bees for all of the Great tips and advice! THANK YOU! Lyle

  • Scott says:

    Very cool I am new at this and expanding all the time so the PVC discussion was great.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.